9
ISOBUS-TC task processing
Using ISOBUS-TC
66
30302710-02-EN
V7.20141016
ISOBUS-TC task processing
Using ISOBUS-TC
The ISOBUS-TC application is an application from Mueller-Electronics which establishes an interface
between the ISOBUS job computer, the TRACK-Leader application and the FMIS (Farm
Management Information System) on the ISOBUS terminal.
With ISOBUS-TC, you can:
▪ Plan and edit ISO-XML tasks on the terminal,
▪ Edit ISO-XML tasks which you have planned on the PC using your FMIS.
All information contained in the order will be transferred by ISOBUS-TC to specialized applications of
the terminal. This means that each application is doing exactly what it can do best:
▪ The position of the field is transferred to FIELD-Nav. It can therefore navigate the vehicle directly
to the field.
▪ The field boundaries, guidance lines, prescription maps and other information about processed
fields stored in the task are transferred to TRACK-Leader. The field can be therefore processed.
▪ The target rates are transferred from a prescription map to the ISOBUS job computer. In this
way, you do not have to worry about inputting the target rates.
▪ ISOBUS-TC documents work duration, and the persons, implements and resources involved.
Adjusting how you use ISOBUS-TC
First of all, you must decide how you will use the ISOBUS-TC application. The operation of ISOBUS-
TC and TRACK-Leader is dependent on this setting.
There are two scenarios in which you can use ISOBUS-TC. Use the "Work with ISO-XML?"
parameter to set the scenario you will work with:
▪ "Yes"
Select this setting if you set up tasks on your PC or if you want to set up tasks on the terminal.
In this instance, you must always start a task before you start work. Only then does the data
exchange between ISOBUS-TC, TRACK-Leader and the ISOBUS-job computer function.
You will need a "ISOBUS-TC" license for this.
▪ "No"
Select this setting if you do not use tasks. Instead, you use application maps in shp format or
enter the application rates directly into the ISOBUS-job computer.
In this instance, ISOBUS-TC only works in the background. You will not need a license for this.
You can also skip the other sections of the instructions regarding ISOBUS-TC.
You can change the mode of the "ISOBUS-TC" application as follows:
1. Change to "Settings" screen:
| ISOBUS-TC |
9
9.1
9.2
Procedure
