8
Troubleshooting
Alarm messages
54
V4.20191001
30322453-02-EN
Troubleshooting
Alarm messages
Alarm message overview
Alarm text
Possible cause
Remedial measure
Pressure is too high.
The pressure in the tank is too high.
Set the optimal pressure.
Pressure is too low.
The pressure in the tank is too low.
Set the optimal pressure.
The fill level is low.
The tank is almost empty.
Fill the tank.
The top link is unlocked. The speed is too
high.
There is still pressure on the top link. This
can cause problems when driving on
roads.
Unlock the top link or put it in float
position.
In order to use this function, set the
sequence to manual.
The automatic application or filling is
activated.
Set the application or filling to manual.
Speed is too low.
A minimum speed is required for the
function you want to perform.
Increase the speed.
Oil filter pressure is too high.
Overpressure in the oil filter.
Check the oil filter. If necessary, clean or
replace the oil filter.
Maximum weight is reached. Check
whether driving on roads is allowed.
The maximum weight for driving on roads
is exceeded.
Observe the permissible total weight.
Maximum weight is reached. The front
axle has been lowered.
The maximum weight for driving on roads
is exceeded.
Check whether the permissible total
weight can be observed with the axle
lowered.
Target Rate is out of reach.
The control system is not capable of
maintaining the target rate.
Drive at a constant speed or control the
target rate manually.
Application pump: Rotational speed is too
low.
The rotational speed of the pump is too
low.
Increase the rotational speed.
Application pump: Rotational speed is too
high.
The rotational speed of the pump is too
high.
Reduce the rotational speed.
The application pump is blocked.
The pump is blocked or switched off.
Check the pump
Overpressure in divider.
The divider is clogged.
Remove the obstruction.
External operating device active. Before
taking over the controls, check the danger
area.
The implement is operated externally.
Check the danger area before operating
other functions.
Not in transport position
Moving parts are not in transport position. Put the moving parts into transport
position.
8
8.1
