6
Configuring TRAIL-Control
Configuring the automatic centering
32
V2.20160912
30322332-02-EN
As the user, you can decide which automatisms should be activated and configure them to a certain
extent.
To activate the automatisms:
1.
Switch to the "TRAIL Control" screen:
2.
- Press.
⇨
The following screen appears:
⇨
An automatism is described on each line. On the left, you can see the conditions under
which a mechanism is executed. On the right, the effects.
3.
To activate functions, set the check mark on the desired line. These functions will be explained in
the following sections.
Centering when exceeding the maximum speed
The system will center the trailed implement as soon as the maximum speed has been exceeded.
The maximum speed is generally 9.32 mph, however, it can be increased by the manufacturer in
some cases when the construction allows it.
For activation, mark the box near these icons.
As soon as the maximum speed has been exceeded, an error message will appear. At the same
time, the trailed implement will be centered. It does this regardless of whether the system was
previously working in manual or in automatic mode.
The centering may not take longer than eight seconds. After this time, the function is aborted,
regardless of whether the middle was reached. TRAIL-Control will then be deactivated.
The automatic centering procedure can be aborted by pressing the
,
(
,
) function keys. Furthermore, the system is switched off.
Centering when switching to manual mode
The system will center the trailed implement as soon as the operating mode is changed from
automatic to manual.
Procedure
6.5.1
Mode of operation
6.5.2