29
Charging the batteries
MūL Technologies battery packs and chargers are designed for use in MARC products exclusively. The battery packs are
designed to offer many hours of service and have a charging life of over 800 cycles.
Charging procedure:
Checking a battery’s charge level:
The battery charge level indicator can be found on the exposed end of the MūL
Technologies
MARC battery when
installed in MARC. To check if a battery is charged, press the button with the power symbol. While depressed, the
charge LEDs will light on the power scale and indicate the battery’s current charge level.
Please note that the status LEDs are not operational while the battery is actively being charged.
The charging port cover rotates to open.
Lifting the cover too
high may result in damage. When accessing the port, be sure
to lift the cover gently and rotate the port cover clockwise to
allow charging cable to be inserted as shown at right.
The battery can be charged while installed in MARC. You must ensure that the same steps are followed in
order and verify the battery’s keys have been removed.
Always plug the charger cable into the battery port before plugging the charger into an A/C outlet to avoid
risk of damage to battery and charger.
While MARC is running,
the battery status is also
shown on the EZ-Go
Navigation panel.
1.
Verify the charger is not plugged into a wall outlet.
2.
Place battery and charger on flat, stable non-
flammable surface.
3.
Ensure battery is in the OFF position with the key
removed.
4.
Gently lift and turn the charging access port cover to
expose the charging port.
5.
Insert the MūL
Technologies battery charger
connector into the charging port.
6.
Plug the charger into a standard wall outlet.
7.
Charging is complete when the
green LED indicator
is on solid.
8.
Unplug the charger from the A/C outlet.
9.
Remove the charger cord from the battery.
10.
Reinstall battery into MARC system.
