Installing 497/498 Electronics (FTIIm)
MTS 793 Controller Hardware
Installation
63
How To Install or Remove a Plug-in Module
Plug-in modules are static sensitive.
Do not install or remove a module with electrical power on. Do not place
modules that contain battery backup on a metal surface. Touch the console or
other ground point before handling a module. Avoid making physical contact
with any circuitry on the modules. Maintain the same potential between the
module circuitry and the equipment or surfaces it contacts by touching the
surfaces first or wearing a wrist strap connected to chassis ground.
To install a module in the chassis:
1. Fully retract the two screws near the handles.
2. Insert the module assembly, and gently slide the module in until it
connects with the backplane.
3. Ensure that the circuit card is seated in the backplane connectors
and tighten the two screws.
To remove a module from the chassis:
1. Loosen the two screws near the module handles.
2. Tug gently on the module to unseat it from the backplane
connectors.
3. Slide the module straight out of the chassis.
CAUTION
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
