Set-Up Instructions Continued
•
Place the bottle on the base and close the door until it is in
the locked position.
•
Ensure that the hot tank switch on back of unit is in the “Off”
position.
•
Connect cooler to power source (
do not use an extension
cord
). This water cooler is intended to be plugged into a
receptacle of the ground fault circuit interrupting type (GFCI).
•
The AquaHostess™ has a self-priming feature that takes
approximately 5 minutes to fill both the hot and cold tanks.
After that time, dispense water from both the hot and cold
tanks to confirm that they have filled. Then turn on the hot
tank.
Note: The maximum water supply should not exceed 80 psi.
MTN Products
1770 Brackett Street
La Verne, CA 91750,
909-629-7301
ACB210r-QSG Rev: 12/21/2015
MTN Products
AquaHostess™ (Bottle Water)
Quick Start Guide
