MTI M200-RS, Quick Start Manual, Page: 2 / 3

MTI M200-RS Development Kit Quick Start Guide
770-00008 Revision 1.1, Copyright © 2020, Impinj, Inc.
Revision 1.2 Copyright © 2020, Microelectronics Technology, Inc.
2
Figure 1
– RS2000 Development Kit Hardware Configuration
3. Start performing tag reads as shown in Figure 2 .
a. Open the Indy Demo Tool software by double-
clicking on the “
Indy Demo Tool.exe
” file.
b.
Press the “Scan” button to detect the COM port corresponding to the development board.
c.
Press the “Connect” button to connect to the development board.
d.
Under the “Inventory” tab, start an inventory by pressing the “Start” button.
i.
At this point, the “Event Log” on the right hand side of the GUI will show the stream of EPCs of the tags
that are read by the Indy RS2000 via the mini-guardrail antenna.
e. Try moving tags relative to the read field of the antenna, and observe the change in the reads displayed in
the Event Log.