MTI Freedom ReAct Interactive, Product Manual, Page: 22 / 30

Freedom ReAct
22
Problem Probable Cause Solution
Cannot open /tmp/media/sd/
mmcblk0p1/mti_data/mti_config.xml Memory card is not installed or not properly
seated Install memory card correctly
mti_data folder is missing on the SD card Copy the mti_data folder to the SD card
mti_config.xml file is missing on the SD card Copy the mti_config.xml file to the SD card
Missing filename.mov, Invalid content
in attract loop A file listed in the mti_config.xml file is
missing. In this case it is a file listed in the
Attract Loop section.
Locate the missing file and copy it to the
SD card
Cannot parse xml: tag mismatch ln4
col72 A syntax error has been detected in the
mti_config.xml file. In this case it is a tag
mismatch. The line and column number
indicates where the xml parser failed. The
actual error could be earlier in the file.
Correct the syntax error(s) in the
mti_config.xml file
Attract Loop missing
Check for proper spelling of the tags and
attributes in the mti_config.xml file. In this
case, the “AttractLoop” tag may be
mis-spelled. Also check the beginning and
end tags. Correct the syntax error(s) in the
mti_config.xml file
Cannot establish connection to a WiFi
access point
Player has stored addresses from a previous
WiFi network
Clear the previous network addresses by
removing the WiFi adapter. Replug the WiFi
adapter to the player and press Connect.
WiFi signal is too weak for adapter to
establish consistent connection.
The player must be moved closer to the WiFi
access point. If this is not possible a different
adapter may work.
Player has valid network addresses
listed in setup menu, but unable to
display web pages.
Player is not communicating properly on all
network ports.
Reboot the player to reset all port
communications.
Player has valid network addresses
listed in setup menu, but unable to
establish connection to DSMS.
One or more player System settings not
correct.
Check System settings in player setup menu.
Verify Host Address is correct and UDP Port is
50400. Reboot the player after making changes
to Hoast Address or UDP Port. Verify Terminal
ID is correct.
Player is not communicating properly on all
network ports.
Reboot the player to reset all port
communications.