CX FLEX
™ SINGLE ALARM ONLY
PRODUCT MANUAL
7
MTI P/N 063-00306 rev 1 ©2019 MTI All Rights Reserved
www.mtigs.com | T:800.426.6844
WARNINGS
LED STATUS INDICATORS
Visual Reference
System Status
Condition
Solution
LED is OFF.
1. Factory Reset
2. No product merchandised or
not properly merchandised
3. Armed
4. Battery needs to be replaced
1. No User or Authorization cards are registered, LEDs will
not flash when properly merchandised, system will not arm
-- Create Whitelist per Page 3.
2. Check connections for proper merchandising.
3. System is armed.
4. Replace battery with CR2450
LED is flashing red, 2 times
every 10 seconds.
Disarmed, but able to be armed
System is disarmed and is ready to re-arm.
LED is continuously
flashing red.
Alarming
System is alarming and requires immediate attention.
1. For indoor use only, shall not be exposed to dripping or splashing.
2. Do not expose to excessive heat sources, sunshine, fire or the like.
3. The socket-outlet shall be installed near the equipment and shall be easily accessible.
4. No user replaceable parts inside, refer servicing to manufacturer specified agency or qualified service
personnel.
5. Only use accessories/battery specified by the manufacturer.
Disposal:
All electrical and electronic products including batteries should be disposed of separately
from the municipal waste stream via designated collection facilities appointed by the
government or the local authorities.
