802.11a Bridge AP5822
MTI Proprietary
Page 20
Internet protocol (TCP/IP) Properties dialog box
n
Click OK to continue and close the Internet Protocol Properties dialog
Notices
If you use the same HPC to ping/connect the same IP bridges, you must clear
the route table in the HPC first. Otherwise, you won’t find other bridge. In
Microsoft Windows system, you can do it by enter following command in DOS
command mode: (assume the ARP program is under the path of
c:\windows\system32)
C:\windows\system32>
ARP –D
3-3 Bridge Initial Configurations
This section describes how to configure the Bridge after booting from Flash memory. Refer to
“
Firmware Update Configuration Window
”
to load the Operating image file to the Flash file
system, if the operating system software should be updated.
Configure the Bridge for its channel frequency and Service Set Identifier (SSID) unique to the
application. This configuration can be done either through a web browser with access to the
built-in Bridge web server. The Bridge can be configured at any time to tailor it for the
application environment. For more information on configuring the Bridge using the web
browser, refer to
“
Bridge Web Server
”
. The following description illustrates the use of the
web browser
