7
Figure 4
SECTION 4: OPERATING YOUR SNOW THROWER
Before Starting
WARNING:
Read, understand, and follow
all instructions and warnings on the machine
and in this manual before operating.
•
The spark plug wire was disconnected for safety.
Attach spark plug wire to spark plug before starting.
Gas And Oil Fill-up
•
At the factory, a plastic
cup
is inserted inside the
fuel tank’s fill opening (beneath the fuel cap) to
prevent debris from entering the fuel tank during
assembly. Remove and discard this cup before
filling up the tank.
WARNING:
Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoor or while the
engine is hot or running. Extinguish
cigarettes, cigars, pipes and other sources of
ignition.
Starting Engine
IMPORTANT:
Prior to operating your snow
thrower, read, understand and follow ALL
instructions to perform adjustments found
under the heading
Auger Control Test
on
page 8 of this manual.
•
Attach spark plug wire to spark plug. Make certain
the metal loop on end of the spark plug wire (inside
the boot) is fastened securely over the metal tip on
the spark plug. See Figure 5.
Figure 5
•
Make certain the fuel shut-off valve, if so equipped,
is in the OPEN (vertical) position.
•
Make certain the auger and traction controls are in
the disengaged (released) position.
•
Move throttle control up to FAST position. Insert
ignition key into slot. Be certain it snaps into place.
Do not turn key. See Figure 4.
NOTE:
Engine will not start unless ignition key is
inserted into ignition slot in carburetor cover. Do not
turn ignition key.
Recoil Starter:
•
Rotate choke knob to FULL choke position (cold
engine start).
•
If engine is warm, place choke in OFF position
instead of FULL.
•
Push primer button three or four times for cold
engine start.
•
If engine is warm, push primer button once only.
Shift Lever
Discharge Chute
Chute Directional Control
Auger
Traction/Auger
Auger Control
Chute
Control Lock
Clean-out Tool
Choke
Primer
Ignition Key
Throttle Control
Spark Plug
Recoil Starter
Handle
Metal Loop
Rubber Boot
