background image

23524 4/17 | 85-000732_INST01_A

CRICKET SAFETY LIGHTS HLT-017 / TLT-007 

6400 WEST 105TH STREET // BLOOMINGTON, MN 55438 // 1-855-883-6563 // WWW.MSWBIKE.COM

Thank you for your purchase! 

At MSW

®

 we believe having essential 

accessories makes a good bike ride great.

 

MSW’s handy lights add visibility 

and an element of safety to you and your bike wherever you may ride. 

 

WARNING:

 

CYCLING CAN BE DANGEROUS. BICYCLE PRODUCTS  

SHOULD BE INSTALLED AND SERVICED BY A PROFESSIONAL MECHANIC. 
NEVER MODIFY YOUR BICYCLE OR ACCESSORIES. READ AND FOLLOW ALL 
PRODUCT INSTRUCTIONS AND WARNINGS INCLUDING INFORMATION ON THE 
MANUFACTURER’S WEBSITE. INSPECT YOUR BICYCLE BEFORE EVERY RIDE. 
ALWAYS WEAR A HELMET.
CONSULT YOUR LOCAL LAW ENFORCEMENT FOR ORDINANCES AND LAWS 
THAT PERTAIN TO RIDING A BICYCLE AT NIGHT. WE STRONGLY RECOMMEND 
USING A FRONT AND REAR LIGHT AS WELL AS WHEEL AND PEDAL 
REFLECTORS WHEN RIDING AT NIGHT. THE BEST WAY TO STAY SAFE  
IS TO RIDE DEFENSIVELY. 

 

WARNING:

 Chemical Burn Hazard. Keep batteries away from children.

This product contains a lithium button/coin cell battery. If a new or used 
lithium button/coin cell battery is swallowed or enters the body, it can  
cause severe internal burns and can lead to death in as little as two hours. 
Always completely secure the battery compartment. If the battery 
compartment does not close securely, stop using the product, remove the 
batteries, and keep the batteries away from children. The risk of a child 
getting a battery is highest when changing batteries, please use caution 
when doing so. If you think batteries might have been swallowed or placed 
inside any part of the body, seek immediate medical attention.
For more information, please visit www.mswbike.com/safety

COMPATIBILITY AND INTENDED USE

MSW Cricket Safety Lights are compatible with 20–40 mm handlebar 
diameters. They are intended to aid visibility in nighttime riding conditions.  

INSTALLATION

Refer to diagrams for additional information.
Place the front white light on the handlebar. Pull the long strap around the 
back and place the hook at the end of the short strap through the 
appropriate hole in the long strap to secure it (fig. 1). 

Place the rear red light against the back of the seatpost. Align the rubber 
strap so that the light is at a 90° angle from the ground (fig. 2).  

Pull the long strap around the back and place the hook at the end of the short 
strap through the appropriate hole in the long strap to secure it (fig. 3). 

NOTE: 

Make sure the lights are not obstructed by racks, bags or cargo.

TO INSTALL BATTERIES

Unscrew the front of the light from the base in a counter clockwise  
direction to access the battery port (figs. 4 and 5). Two CR2032 batteries  
are required. The light will run for 50 hours in “steady” mode, and 150 hours 
in “flash mode”. 

OPERATING THE LIGHT

Press down on the light’s lens to turn on, switch modes, and turn off.

ONGOING MAINTENANCE

Do not submerge the lights in water.
A coin-cell, lithium-ion battery is used in this device. If these guidelines  
are not followed, batteries may experience a shortened lifespan or may 
present a risk of damage to the device, fire, chemical burn, electrolyte leak, 
and/or injury.
Do not leave the device exposed to a heat source or in a high-temperature 
location, such as in the sun in an unattended vehicle. To prevent the possibility 
of damage, remove the device from the vehicle or store it out of direct 
sunlight, such as in the glove box.
Do not disassemble, modify, remanufacture, puncture, or damage the device  
or batteries.
Do not immerse or expose the device or batteries to water or other liquids, 
fire, explosion, or other hazard.
Do not use a sharp object to remove the batteries.
KEEP BATTERIES AWAY FROM CHILDREN.
NEVER PUT BATTERIES IN MOUTH. Swallowing can lead to chemical burns, 
perforation of soft tissue, and death. Severe burns can occur within two 
hours of ingestion. Seek medical attention immediately.
Replaceable coin-cell batteries may contain perchlorate material. Special 
handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Only replace batteries with correct replacement batteries. Using other 
batteries presents a risk of fire or explosion.
Do not operate the device outside of the temperature ranges specified  
in these instructions.
Contact your local waste disposal department to dispose of batteries  
in accordance with applicable local laws and regulations.

Figure 1

Figure 3

Figure 2

Figure 4

Figure 5

Reviews: