Rebuilding RAID Array
A RAID 1, RAID 5 or RAID 10 volume is reported as
Degraded
when one of its hard
drive members fails or is temporarily disconnected, and data mirroring is lost. As a
result, the system can only utilize the remaining functional hard drive member. To re-
establish data mirroring and restore data redundancy, refer to the procedure below
that corresponds to the current situation.
1.
Power off.
2.
Replace the failed hard drive with a new one that is of equal or greater capacity.
3.
Reboot the system and go to
BIOS > SETTING > Advanced > Intel(R) Rapid Storage
Technology
.
4.
Select the
Degraded
RAID volume from the
Intel(R) Rapid Storage Technology
screen to enter the
RAID VOLUME INFO
screen.
5.
Select the
Rebuild
item and press
Enter
key to rebuild the new hard drive.
63
RAID Configuration
Summary of Contents for MAG B460M BAZOOKA
Page 3: ...3 Safety Information Installing a Processor https youtu be 4ce91YC3Oww 1 2 3 6 4 5 7 8 9 ...
Page 8: ...8 Safety Information Installing SATA Drives http youtu be RZsMpqxythc 1 2 3 4 5 ...
Page 9: ...9 Safety Information 1 Installing a Graphics Card http youtu be mG0GZpr9w_A 2 3 4 5 6 ...
Page 10: ...10 Safety Information Connecting Peripheral Devices ...
