6
Inspection
Inspection Component
Inspect For:
io1 case
Inspect for cracks, dents, and chipping.
Alarm sounding hole
Inspect for debris blocking alarm hole (remove if present). Confirm alarm sounds according to
status indicators in Table 1 .
Charging line
Inspect charging line and verify they are free of any cuts or abrasions. The cables should be
fully secured at the each connection point and there should be no loose portions of wire.
Labels
Inspect labels to ensure they are present and all information is legible. The labels should be free
from abrasions or peeling.
See MSA V-TEC PFL Manual, MSA P/N 63011-96 (included in box) for Retractable Lanyard portion.
7
Troubleshooting
If the io1 is not working, perform a hard reset. See Table 1 for status indicators.
Press the reset button on the side of the io1 plastic housing with a small paperclip to turn it off. Do this again to turn the io1
back on.
Figure 4 Reset io1
14
V-TEC® io1
6 Inspection
US
