MSA SUPREMATouch MCP 20, Operating Manual

Page: 61 / 241

61
Entering System Parameters
GB
SUPREMATouch
Fig. 39 IBR
Interface Tests
Test of the analogue outputs
Fig. 40 Test of the analogue outputs
Analogue outputs can be tested with the help of this subwindow. The desired analogue output is
selected using the output number field and the current to be tested is set using the output value
field. The test can be completed using the
End button. The regular, input dependent value is
displayed again in the output thereafter.
Field Field Type Function
Measuring
point
Display
To select the measuring point, for which the sensor current
should be set.
Tag Display Displays the tag defined for the selected measuring point.
Sensor current
reference
value
Number input
The value to which the bridge current should be set can be
defined here. This value is sensor type dependent, but it can
also be adjusted for special applications.
Current
measure value
Display Displays the actual measured bridge current.
Status Display
Displays the current preadjustment status of this measuring
point.
Start Button The preadjustment is started by tapping this button.
End Button The preadjustment is finished by tapping this button.