MSA SUPREMATouch MCP 20, Operating Manual

Page: 51 / 241

51
Entering System Parameters
GB
SUPREMATouch
Status Texts
Fig. 31 Status texts
Use this window to define sensor type specific texts for specific signal ranges.
These are displayed in the measuring value list with a letter
F prefix. (e.g. F:OpticErr ). Texts can
be defined for all remote sensors provided that ranges are specified for them. Texts can be
defined arbitrarily, the same texts are allowed for more than one sensor.
In addition, the user can freely define the signal ranges in the range from 0–400 mV for change-
able remote sensors. However, the signal ranges must not overlap.
UA
idle
(Limit for
signal fail)
Number
(integers)
Adjusting
range: 50–
350, must
be < UA
min
This field displays the maximum signal UA for the status
signal fail . Measuring values below this limit value are
displayed as signal fail.
This value can only be set for the three user-changeable data
sets.
UA
over
(Limit for
“overflow”)
Number
(integers)
Adjusting
range:
2000–2200 This value defines the sensor signal UA of the remote sensor
for the measuring range overflow display. Measuring values
above this value are displayed as
overflow .
This value can only be set for the three user-changeable data
sets.
T
supp
(Warm-up
period)
Number
(integers)
Adjusting
range: 10–
300
The warm-up time in seconds can be set here. This specifies
how long a sensor will remain in the warm-up status (display
suppressed ) after it has been switched on. This time is neces-
sary because different sensors need a different length of time
to warm up and the correct measuring value is displayed.
This value can only be set for the three user-changeable data
sets.
OK Button
By tapping this button, the completed settings are applied to
the selected head.
Cancel Button
By tapping this button, the completed settings of the selected
head are canceled.
Field Field Type Function