mru SWG100 BIOEX, User Manual, Page: 95 / 150

MRU GmbH SWG 100 BIO Ex User Manual
Page
95
of
150
11.4. Main menu measurement
This menu is the root of all menus and will be shown automatically as soon as the self-
test is finished. The title bar you can see on the left the current measurement cycle status
and how long it lasts and the actual sampling point number . In the middle section of
the actual measurement values are displayed .
Representation during the status "measurement"
The title bar you can see on the left "measurement" and the remaining measurement
duration, and the right
light blue highlighted sampling point number SPx (x = 1 to 4)
that is being measured. In the middle section of the menu, the current (live) values are
displayed.
Representation outside the status of "measurement"
The title bar you can see on the left "air purging" or "gas sampling SPx" and the
remaining duration of the current status. On the top right you can see the
yellow
highlighted
sampling point number SPx previously measured or that you have selected
for display and their measuring values are hold until it is measured again. In the middle
section of the menu hold measured values of these measurement sites are displayed.
Change the Display Zoom / Standard
Two display modes are available:
•
standard view mode with 6 values per page, up to 4 pages (indicating up to 24
values)
•
zoom view mode with 2 values per page, up to 6 pages (indicating up to 12
values)
The indication mode can be swapped with the menu key and the selection of zoom view
or standard view.
For devices with just one measuring point the switching is additional possible with the
arrow keys up / down.
Change the displayed page
Use the arrow keys left / right can be changed in both display modes the page. The new
page number is displayed in the title bar for a moment just after the successful change.
Change sampling point displayed
For analyzers with several measuring points can used the arrow keys up / down the
displayed (not measured) measuring point can be changed. In this way you can get an
overview very quickly over the last measured values for all points. In the background,
the analyzer uses the measurement cycle continues uninterrupted. However, once a
measurement phase is completed, the display automatically switches to the actual
measurement location.