USER MANUAL DM9600
MRU GmbH, D-74172 Neckarsulm
9 / 57
2
Introduction
•
This manual enables you to understand and safely operate this MRU
Analyzer
.
•
Please read this manual with great vigilant and get familiar with the
product before using it.
•
This analyzer may only be operated by competent personnel and for its
intended use.
•
Please pay special attention to all safety directions and warnings to
prevent personal injuries and damaging of the product.
•
We can’t be held responsible for any injuries
and/or damages that oc-
cur by not following the instructions in this manual.
•
Always keep the manual near you when working with the analyzer, to
be able to read instructions as needed. Please ensure to hand over all
documents to when handing the analyzer over to others.
2.1.
Intended use
The analyzer is intended as a monometer for pressure and temperature
measurement of non-explosive gases.
Optionally, an HC probe for locating leaks in gas pipes or an external
pressure sensor for measuring higher pressures can be connected via
the AUX socket.
The analyzer is specifically not intended as a safety device or personal
protective equipment.
The analyzer should not be used as a warning device to warn people
against the presence of harmful gases.
The analyzer must be used according to instructions for the intended
use.
Our analyzers are checked according to the following regulations:
VDE
0411 (EN61010)
and
DIN VDE 0701
before they leave the MRU
GmbH factory.
MRU technical products are designed and manufactured according to
DIN 31000/ VDE 1000
and
UVV = VBG 4
of the professional guilds for
fine mechanics and electrical engineering.
MRU GmbH assures that the analyzer complies to the essential require-
ments of the legal regulations of the member states of the electro-
magnetic compatibility
(89/336/EWG)
WARNING
Risk from manipulations to the measuring device
Operational safety hazard
►
Modifications or changes to the measuring device are not
allowed.
