USER MANUAL DM9600
MRU GmbH, D-74172 Neckarsulm
16 / 57
5
Settings
After the analyzer has been inspected and is ready for start-up it can be
switched on and personalized settings can be entered. These settings
can be changed at any time.
5.1.
Preparatory steps
•
Unpack the analyzer.
•
Read the User Manual completely.
•
The analyzer leaves the factory assembled and ready for use.
Nevertheless, check the device for completeness and integrity.
•
Charge the battery of the analyzer for about 5 hours.
•
Check date and time. Modify if needed.
5.2.
Analyzer settings
The following adjustments can be made in the menu
„Extras“
:
:
Country
When changing the country, country specific
pre-settings and measurement procedures will
be activated.
Please pay special attention if the country
specific settings and procedures are working
according to their regulations
Language
Select the operating language
LCD Brightness [%]
5
–
100
The LCD brightness is depending on tempera-
ture and personal perspective of each user.
50% brightness are normal at 68°F (20°C)
Keyboard beep
ON / OFF
Turn the Keyboard beep ON or OFF
Helping hints
ON / OFF
Turn the feature Helping hints ON or OFF
Temperature unit
°C / °F
Select the units for temperature
Pres. unit
Pa...mbar...
mmHg...etc.
Select the units for pressure
Pressure P1
Positive / nega-
tive
Select the sign
Logo
ON / OFF
Select if logo at switch on
Printer type p
MRU / HP
Select between MRU protocol and HP proto-
col
