MRMC CINEBOT Bolt Jr+, Quick Start Manual

Page: 31 / 52

Bolt™ Jr+ Quick Start Guide
27
Starting up the Bolt™ Jr+ on Track system
Once you have attached all the cables, you power up the rig by switching
on the components in the order described below.
1. Make sure you have secured the area around Bolt Jr+.
Put up guard rails around Bolt Jr+ (and the track) as
necessary, and tell others on the set that you are now
powering up the rig.
2. Release the E-stop on the Bolt Jr+ Base by turning the
red button clockwise until the button pops up. Do not
release the other E-stop by the computer stack yet.
3. Power up Bolt Jr+ itself as follows:
For more details on the LEDs during power up on CR800 controller
that is housed inside the base, refer to page 24.
4. Power up the Flair computer system and all of its components,
including the RT-14 interface box. You can do this while the robot is
powering up (step 2).
Do not start the Flair application yet .
5. On the Flair PC, start the Flair application by double-clicking on the
Flair icon on the Desktop.
Flair automatically loads the relevant firmware into all attached axis
boards, including:

The Quad Board that runs the track motor

The Ulti-box that is mounted on the Bolt Jr+ arm

Any additional interface boxes that are attached to the
computer stack and any model movers
Turn on the power switch on
the side of the Bolt Jr+ Base.