MRMC CINEBOT Bolt Jr+, Quick Start Manual

Page: 18 / 52

Bolt™ Jr+ Quick Start Guide
14
Mounting the Optional Riser(s)
Bolt Jr+ can include optional risers if higher arm reach is required. These
come in two sizes: 150mm and 300mm; either or both of them can be
used. Use the following instructions to mount any riser on the pedestal:
1. Remove the arm from the base by unscrewing the 4xM12 screws
and using a gantry hoist to lift the arm.
2. Remove the mounting plate from the base by unscrewing the 3xM12
screws.
3. Lower the riser on the base aligning the three screw cavities and
tighten the 3xM12 screws to secure the riser on the base.
4. Mount the mounting plate on the riser using 3xM12 screws.
5. Carefully lower the arm on the base aligning the screw cavities on
the mounting plate and those on the robot arm. Screw 4xM12 to
secure the arm on the base.