MRA 4025066169757, Mounting Instructions, Page: 3 / 9

3
GB
MOUNTING INSTRUCTIONS
DUCATI Streetfighter V4/S 2020-
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number Article Article No.. Required tools
1 MRA windscreen --- Allen key 3, 4, 5, 6mm
Torque wrench
2 Suspension rods (curved) 10796
2 Ball socket 10543
2 Clamp block 10696
2 Panels 10542
4 Lens head screws, M5x16 10554
4 Allen screws M5x16 10560
8 Nuts M5 10557
2 Push-on cap 10550
2 Allen screws M8x55 10791
2 Bushings 15 mm 10777
Installation of the mount onto the windscreen:
1. Insert the nuts (7) into the hexagonal recesses in the sides of the ball clamps (2) and screw in the
Allen screws (6) (do not tighten yet) (P1).
2. Place the rod clamp onto the rod.
3. Attach the suspension rod (1) to the ball clamp (2) and the panel (4) to the fairing screen. Use the
flat screws (5) and the nuts (7) for them and tighten them (P1).
Mounting the windscreen on the motorcycle:
4. Place the motorcycle on a flat surface.
5. Loosen the handlebar clamp bracket screws evenly.
6. Remove the front 2 clamping screws.
7. Put the windscreen with the mount in position on the motorbike and attach the suspension rods to
the handlebar clamp brackets with the M8 x 55 screws and the 15 mm distance sleeves. We
recommend lightly greasing the screw on the thread and under the head. Pay attention to the
handlebar position.
8. Adjust the fairing screen and the holding rods (P2+3) and tighten the handlebar clamp bracket
screws as shown in figure 4.
9. Depending on the position of the mount and the windscreen, the holding rods can be shortened and
the ends can be covered with the rod caps.
10. Apply the protective edge strip profile as shown in the last two figures. Cut off the rest if required.
Push the clamping sleeves over the ends of the protective edge strip profile and lightly press these
together using a pair of pliers to secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: