8 Operation
Maschinenfabrik Reinhausen GmbH 2020
94
3587317/21 EN
TAPCON
®
Visualization release
You can use this parameter to set the interfaces via which you can access
the visualization:
▪ Only ETH 2.x
▪ ETH 1 and ETH 2.x
You can only set this parameter if the device is equipped with the optional
control system connection via Ethernet (TCP/IP) and the optional interface
for visualization.
SSL/TLS encryption
You can use this parameter to set whether the process for accessing the vi-
sualization should be carried out over an SSL/TLS-encrypted connection.
TLS version
You can use this parameter to set the accepted TLS versions. If you would
like to establish an encrypted connection to the visualization, you must use
an accepted TLS version. You can select the following options:
Option
Accepted TLS versions
>= 1.0
▪ 1.0
▪ 1.1
▪ 1.2
>= 1.1
▪ 1.1
▪ 1.2
>= 1.2
1)
▪ 1.2
Table 20: TLS version
1)
This option can be selected only if the TLS version is supported by the
connected peripheral equipment.
Activate DNS (optional)
You can use this parameter to activate DNS for name resolution. If you
would like to use the MQTT protocol, you can establish the connection to the
MQTT via a DNS server as an option. Also set the parameters necessary for
the MQTT [
Section 8.4, Page 95] protocol.
DNS server (optional)
You can use this parameter to set the IP address of the DNS server.
Summary of Contents for TAPCON
Page 1: ...Voltage regulator TAPCON Operating Instructions 3587317 21 EN ...
Page 333: ......
