MR TAPCON 250, Operating Instructions Manual

Page: 107 / 216

9 Operation
Maschinenfabrik Reinhausen GmbH 2022 107 8595028/00 EN TAPCON
®
250
Correction factor and offset Setting a correction offsets systematic errors of the analog signals. The cor-
rection is determined by multiplying a factor by the sum of the offset. The
minimum and maximum values of the function values apply as a limit value
for the correction. There is no limit for the correction offset.
Max.
Min.
Measured variable
Max. Min. Analog signal
Correction factor
Correction offset
Figure 57: Analog signal with linear characteristic curve, correction factor <1 and correction off-
set
NOTICE Damage to the device and sensors!
Incorrectly connected and configured analog inputs may result in damage to
the device and sensor.
► Follow the information about connecting analog sensors.
► Configure analog inputs according to the connected sensors.
The following information is displayed to you in tabular form for configuring
the analog inputs. Grayed-out elements cannot be changed.
Property Options
Function Function of the analog input (I: ...). You can adjust the
designation.
Signal type Select signal type of analog sensor or deactivate analog
output.
▪ 4...20 mA
▪ 0…20 mA
▪ 0…1 mA
▪ 0…2 mA
▪ 0…10 V
Card/channel Select the slot and channel of the analog sensor. Note the
connection diagram supplied.
Unit
1)
Set the unit of the signal.