MR ECOTAP VPD CONTROL PRO, Operating Instructions Manual, Page: 173 / 192

8 Operation
Maschinenfabrik Reinhausen GmbH 2018 173 5252433/02 EN ECOTAP
®
VPD
®
CONTROL PRO
To link the function, proceed as follows:
ü
The desired event number is known.
1. Go to Settings > Parameters > Link functions .
2. Select the desired parameter.
3. Enter the desired event number.
4. Press the Accept button to save the modified parameter.
8.18.2 Linking control system messages
You can link each event with a control system message. The device pro-
vides 10 SCADA messages for this purpose.
To forward control system commands, you need to link the control system
messages to the
Generic digital input or Generic SCADA command events.
When you link a SCADA message to an event, the device sets the data point
to "On" when the event occurs. When the event stops, the device sets the
data point to "Off". A parameter is available for each available SCADA mes-
sage.
Figure 109: Linking SCADA messages
In order to establish the link, you have to enter the corresponding event
number in the desired parameter.
If you enter event number 500, the link is disabled.