MR ECOTAP VPD CONTROL PRO, Operating Instructions Manual

Page: 161 / 192

8 Operation
Maschinenfabrik Reinhausen GmbH 2018 161 5252433/02 EN ECOTAP
®
VPD
®
CONTROL PRO
Signal Description
W2: Q_m L3 Winding 2: Reactive power L3 (average value)
W2: Q_m Winding 2: Reactive power in total (average value)
Auto block Auto mode blocked
HSR tap position ↓ High-speed return lower step
HSR tap position ↑ High-speed return raise step
Req. HSR tap position
↓ High-speed return request lower step
Req. HSR tap position
↑ High-speed return request raise step
W1: I>> Winding 1: Limit value I>> exceeded
W2: I>> Winding 2: Limit value I>> exceeded
W1: U>> Winding 1: Limit value U>> exceeded
W2: U>> Winding 2: Limit value U>> exceeded
U Desired (prim.) Desired voltage value (on primary side)
U Desired Desired voltage value (on primary or secondary side, in ac-
cordance with configuration of measured value display pa-
rameter)
Tap position Tap position
W1: P L1 Winding 1: Active power L1
W1: P L2 Winding 1: Active power L2
W1: P L3 Winding 1: Active power L2
W1: P Winding 1: Active power in total
W1: S L1 Winding 1: Apparent power L1
W1: S L2 Winding 1: Apparent power L2
W1: S L3 Winding 1: Apparent power L3
W1: S Winding 1: Apparent power in total
W1: f Winding 1: Frequency
W1: φ U1/I1 Winding 1: Phase angle U1/I1
W1: φ U2/I2 Winding 1: Phase angle U2/I2
W1: φ U3/I3 Winding 1: Phase angle U3/I3
W1: cos(φ) L1 Winding 1: Power factor L1
W1: cos(φ) L2 Winding 1: Power factor L2
W1: cos(φ) L3 Winding 1: Power factor L3
W1: cos(φ) Winding 1: Power factor in total
W1: I N Winding 1: Neutral conductor current
W1: I L1 Winding 1: Current L1
W1: I L2 Winding 1: Current L2