8 Operation
Maschinenfabrik Reinhausen GmbH 2018
127
5252433/02 EN
ECOTAP
®
VPD
®
CONTROL PRO
Assign IP addresses to both web-based visualization and SCADA (optional)
in different subnets. Otherwise you will not be able to establish a connec-
tion.
1. Go to
Settings > Parameters > DNP3 > IP address
.
2. Enter the IP address.
3. Press the
Accept
button to save the modified parameter
Subnet mask
You can use this parameter to set the subnet mask.
Be sure to enter a valid network mask that is not 0.0.0.0, otherwise it will not
be possible to connect to the device.
To set the subnet mask, proceed as follows:
1. Go to
Settings > Parameters > DNP3 > Subnet mask
.
2. Enter the subnet mask.
3. Press the
Accept
button to save the modified parameter
Gateway address
You can use this parameter to set the gateway's IP address.
If you set the value to 0.0.0.0, no gateway is used.
To set the gateway address, proceed as follows:
1. Go to
Settings > Parameters > DNP3 > Gateway address
.
2. Enter the gateway address.
3. Press the
Accept
button to save the modified parameter
TCP port
You can use this parameter to set the TCP port.
To set the TCP port, proceed as follows:
1. Go to
Settings > Parameters > DNP3 > TCP port
.
2. Enter the TCP port.
3. Press the
Accept
button to save the modified parameter
Summary of Contents for ECOTAP VPD CONTROL PRO
Page 1: ...Voltage Regulator ECOTAP VPD CONTROL PRO Operating Instructions 5252433 02 EN ...
Page 190: ......
Page 191: ......
