PAGE 24 — CA4HC WALK-BEHIND TROWEL • OPERATION MANUAL — REV. #1 (06/24/20)
Float Pan Installation (Optional)
Float pans attach to the trowel blades and allow the trowel
to ‘float’ on wet concrete. The disc design allows early
floating and easy movement from wet to dry areas. Float
pans are also very effective at embedding large aggregates
and surface hardeners.
1. Lift the trowel just enough to slide a float pan under the
blades. Lower the trowel onto the pan with the blades
adjacent to the Z-clips.
Figure 13. Float Pan Installation
2. Rotate the blades into position under the Z-clips. Be
sure to rotate the blades in the operational direction
of travel, or use the engine to rotate the blades into
position.
3. Secure the blade tie-downs to the far side of the Z-clip
brackets with the tie-down knobs.
4. Make sure the blade edges are secured under the
Z-clips and the tie-downs are secured completely over
the edges of the blade bar.
BLADE
FLOAT DISC/PAN
BLADE
TIE-DOWN
Z-CLIP
TIE-DOWN
KNOB
BLADE BAR
WARNING
Lifting/crush hazard.
DO NOT
lift the
trowel with a float pan attached.
SETUP
To
order
go
to
Discount-Equipment.com
