151
12. Press the Left or Right keys to cycle through the options (1-8 and
Factory). When the desired number displays, press the
↵
key to select it.
The following message displays:
NOTE:
If the configuration number has not been saved previously, the
following error message displays:
If this error message displays, see “Saving A Configuration” on
page 147. Once you have saved a configuration, repeat the steps in
this procedure.
Modifying A Saved Configuration
You can change a saved configuration by rewriting over it. For example, you
can modify Config. 1, shown below. Suppose you want to keep all the settings
but you want to select the parallel Centronics interface instead of the
IEEE 1284 interface.
1.
Load the configuration to be changed (for example, Config. 1).
a.
Press the
key to enter the menu configuration. MEDIA SETUP is
selected.
b.
Press the Right key until the following displays:
c.
Press the
↵
key to enter the CONFIGURATION menu.
d.
Press the Down key until the following displays:
e.
Press the Left or Right keys to cycle through the options Factory, 1-8.
Power-Up Config.
X
*
CONFIG. DOES NOT
EXIST/Save First
..
.
CONFIGURATION
Load Config.
1*
