MP Systems AK CB20, Installation, Operation & Maintenance Manual

Page: 9 / 81

3 MPSYSTEMS-M-001/06
2.1. General Rules
R Series has been designed and constructed in such a way to minimize any possible cause of danger
to the operator and their surroundings. However, residual risk still remains and can arise through
improper use of the machine and can be of various types;

Risk due to escaped coolant/cutting fluid.

Risk due to excessive noise caused by operating outside permitted limits.

Risk of accidents caused by scraping against edged sheet metal profiles.
2.2. Prevention of Mechanical Risks
In operation, R Series contains some moving parts. These parts constitute a possible source of
danger to the operator, therefore in order to avoid any possible danger it is necessary to observe the
following operational rules;

Before removing any panels/guards, ensure electricity supply to the machine has been
switched off.

Never start R Series with any panel/guards removed.

The additives present in coolant/cutting fluid may have a corrosive action that can irritate the
skin and eyes.
o
Always wear gloves & eye protection when handling coolant/cutting fluid.
2.3. Prevention of Electrical Risks
When power to the machine is switched on, the machine is a source of danger, especially if the basic
safety rules are not followed. In order to avoid any possible danger it is necessary to observe the
following basic operation rules;

When making electrical connections to the R Series, observe state and federal electrical codes
or those otherwise in force. Observe the technical supply conditions imposed by the power
supply companies.

Before carrying out any work on the R Series, switch off the electrical supply at the main
isolator.

Work on the R Series must only be carried out by authorized personnel.

Always replace worn out or defective components.

Before working on electrical equipment always read the manual that contains the machines
circuit diagram.

Always make sure there is no electric power to the equipment.

Check to ensure the machine is earthed before powering on the R Series.

Check all electrical connections and connecting cables are well insulated and replace any
cables that are evidently worn or damaged.

Be sure to use power cables supplied by MP SYSTEMS or that have been approved by MP
SYSTEMS .