Moyer Diebel I-MHM4, Technical Manual

Page: 27 / 66

TROUBLESHOOTING
Perform the seven checks listed below in the event that your dishwasher does not operate
as expected.
1. All switches are ON
2. Drain-overflow assemby is in place and seated
3. Wash and rinse nozzles are clean
4. Wash and rinse pipe assemblies are installed correctly
5. Scrap screens are properly positioned
6. Thermostat(s) are properly adjusted
7. Detergent and rinse additive dispensers are adequately filled.
If a problem still exists, use the following table for troubleshooting.
CONDITION CAUSE SOLUTION
Machine will not start Doors not closed ............................ Make sure doors are fully closed
Door safety switch faulty ................ Contact your service agency
Start switch faulty ........................... Contact your service agency
Main switch off ................................ Check disconnect at main panel
Overload protector tripped ............. Reset overload in Control Box
Machine washes Fill/Extended wash switch in .......... Push Fill/Extended wash switch
constantly extended wash position to the center position
Low or no water Main water supply is turned off ....... Turn on house water supply
Drain-overflow assembly is not ...... Place and seat drain-overflow
in place and seated
Machine doors not fully closed .......
Close doors securely
Faulty fill valve ................................ Contact your service agency
Machine not filled initially ................ Hold fill switch UP to fill
Clogged strainer in fill valve ........... Clean or replace
Stuck or defective float ................... Check floats and clean
Continuous water filling Stuck or defective fill switch ........... Contact your service agency
Fill valve will not close .................... Clean or replace
Drain-overflow not in place ............. Install drain-overflow assembly
Stuck or defective float switch ........ Inspect or replace float switch
Wash motor not running Overload protector tripped .............. Reset overload in Control Box
Defective motor .............................. Contact your service agency
Wash tank water Incoming water temperature ........... Raise temperature to:
temperature is low at machine too low 110-140 ° F/43-60 ° C
when in use Defective thermometer ................... Check or replace
Defective thermostat ...................... Check for proper setting
or replace
Defective heater element ............... Check or replace
Defective solenoid valve ................. Check or replace
Heater elements ............................. Clean and delime
have soil/lime buildup
TROUBLESHOOTING
19