UC-7400-LX Plus User’s Manual
Getting Started
2-2
Powering on the UC-7400-LX Plus
Connect the SG wire to the Shielded Contact located in the upper left corner of the UC-7400-LX
Plus, and then power on the computer by connecting it to the power adaptor. It takes about 30 to
60 seconds for the system to boot up. Once the system is ready, the Ready LED will light up, and
the model name of the computer will appear on the LCM display.
NOTE
After connecting the UC-7400 LX Plus to the power supply, it will take about 30 to 60 seconds for
the operating system to boot up. The green Ready LED will not turn on until the operating system
is ready.
Connecting the UC-7400-LX Plus to a PC
There are two ways to connect the UC-7400-LX Plus to a PC: (1) Through the serial console port,
and (2) via Telnet over the network.
Serial Console
The serial console port gives users a convenient way of connecting to the UC-7400-LX Plus
console utility. This method is particularly useful when using the computer for the first time. The
signal is transmitted over a direct serial connection, so that you do not need to know any of the IP
addresses in order to connect to the serial console utility.
Use the serial console port settings shown below.
Baudrate
115200 bps
Parity
None
Data bits
8
Stop bits:
1
Flow Control
None
Terminal
VT100
Once the connection is established, the following window will open.
To log in, type the Login name and password as requested. The default values are both
root
:
Login: root
Password: root