ToughNet NAT Router User's Manual
Routing
4-3
Clickable Buttons
Add
For adding an entry to the Static Routing Table.
Delete
For removing selected entries from the Static Routing Table.
Modify
For modifying the content of a selected entry in the Static Routing Table.
NOTE
The entries in the Static Routing Table will not be added to the ToughNet NAT Router’s routing table until you
click the Activate button.
RIP (Routing Information Protocol)
RIP is a distance-vector routing protocol that employs the hop count as a routing metric. RIP prevents routing
from looping by implementing a limit on the number of hops allowed in a path from the source to a destination.
The RIP
Setting
page is used to set up the RIP parameters.
RIP State
Setting
Description
Factory Default
Enable/Disable
Enable or Disable RIP protocol
Disable
RIP Version
Setting
Description
Factory Default
V1/V2
Select RIP protocol version.
V2
RIP Distribution
Setting
Description
Factory Default
Static
Check the checkbox to enable the Redistributed Static Route
function. The entries that are set in a static route will be
re-distributed if this option is enabled.
Unchecked
