B
B.
CLI Command Support for the
EOM-G103-PHR-PTP Module
Basic Commands
Command
Display Information
quit
Exit command line interface
exit
Exit command line interface
reload
Halt and perform a cold restart
reload factory-default
Halt and perform a cold restart with factory default
terminal length
Configure terminal page length
terminal default
Reset the terminal length to the default
copy xmodem device-firmware
copy System firmware from xmodem
save
Save running configuration to flash
clear logging
clear System event logs
clear counters
Clear statistics counters
Show Commands
Command
Display Information
show version
System version information
show system
System hardware and software status
show interfaces hw_interface
Display hardware interface configuration
show clock
Display the system clock
show redundancy PRP/HSR
Display redundancy protocol status
show redundancy mode
Current redundancy protocol mode
show mac-address-table [learned/interface]
Display MAC address forwarding table by
interface/learned
show logging event-log
Display system event logs
show vlan-filtering
Display vlan filtering configuration
show multicast-filtering
Display Multicast Filtering status