OnCell G3470A-LTE
Getting Started
2-2
First-time Installation and Configuration
Before installing the OnCell G3470A-LTE, make sure that all items in the package checklist are in the box. In
addition, you will need access to a notebook computer or PC equipped with an Ethernet port. The OnCell
G3470A-LTE has a default IP address that you must use when connecting to the device for the first time.
Step 1: Inserting a SIM Card
Insert one or two 2G/3G/4G SIM cards into the SIM slots located on the bottom of the OnCell G3470A-LTE.
Installing a SIM Card
The SIM card slots are inside the OnCell G3470A-LTE’s housing. To
install a SIM card, complete the following steps:
1.
Turn off the OnCell G3470A-LTE.
2.
Remove the screw to remove the SIM card slot cover.
3.
Install a SIM card into a SIM card slot. Do the following:
a.
For SIM 1, orient the gold contacts facing down and the cut-
off edge to the left.
b.
For SIM 2, orient the gold contacts facing up and the cut-off
edge to the right.
4.
Install the screw to secure the SIM card slot cover.
Step 2: Turning on the OnCell G3470A-LTE
Turn on the OnCell G3470A-LTE by connecting a power terminal block to a DC power source.
Step 3: Connecting the OnCell G3470A-LTE to a Computer
Since the OnCell G3470A-LTE supports MDI/MDI-X auto-sensing, you can use either a straight-through
cable or crossover cable to connect the OnCell G3470A-LTE to a computer. If the LED indicator on the
OnCell G3470A-LTE's LAN port lights up, it means a connection has been established.
Step 4: Configuring the Computer’s IP Address
Set an IP address on the same subnet as the OnCell G3470A-LTE. Since the OnCell G3470A-LTE’s default IP
address is
192.168.127.254
, and the subnet mask is
255.255.255.0
, you should set the IP address of
the computer to
192.168.127.xxx
.
NOTE
After you select
Maintenance
>
Load Factory Default
and click the
Submit
button, the OnCell G3470A-
LTE will be reset to factory default settings and the IP address will be reset to
192.168.127.254
.
