ioLogik E2200 Series
Using ioAdmin
3-32
Click&Go Logic Tab
The Click&Go Logic tab is available after logging in as an administrator. This is where the ioLogik’s device
system is configured. With a set of rules (known as a ruleset) defined through Click&Go, the ioLogik can report
I/O status to a host as soon as user-defined I/O conditions have been met. Refer to the Click&Go V2 User’s
Manual, which can be downloaded from Moxa’s website, for more detailed information on defining rules.
Click&Go Logic
changes do not take effect until the ioLogik E2200 series has restarted. Click
Upload
to
upload the logic values and restart the ioLogik E2200. After logging back in as an administrator and returning
to the Click&Go Logic tab, click
Retrieve
to view the current ruleset. Click
Run
to activate the ruleset and
Stop
to deactivate it.
To learn more about “Click&Go” please refer to the following website:
http://www.moxa.com/remote_io/ClicknGo.htm
ATTENTION
I/O channels used by Click&Go Logic
cannot be controlled externally
using ioAdmin’s
Test
function,
other
Modbus/TCP master software, SCADA software, or SMS commands.
Summary of Contents for ioLogik E2210
Page 138: ...ioLogik E2200 Series Cable Wiring D 4 Digital Output Sink Type...
Page 139: ...ioLogik E2200 Series Cable Wiring D 5 RTD Input Wiring Structure 2 wire 3 wire...
Page 140: ...ioLogik E2200 Series Cable Wiring D 6 Thermocouple Input Wiring Structure 2 wire...
Page 144: ...ioLogik E2200 Series Input and Output Terminal E 4 ioLogik E2262 I O left to right...
