CN2510
Getting Started
2-2
Hardware Installation
Desktop
Place your CN2510 on a clean, flat, well-ventilated desktop. For better ventilation, attach the 4 pads from the
desktop kit to the bottom of the unit, and leave some space between the CN2510 and other equipment. Do not
place equipment or objects on top of the unit, as this might damage the server.
Rackmount
CN2510 is designed to be mounted on a standard 19-inch rack. Use the enclosed pair of L-shaped metal
brackets and screws to fasten your CN2510 to the rack cabinet. Each L-shaped bracket has 6 holes, leaving two
outer or inner holes available for other uses. You have two options. You can lock either the front or rear panel
of the CN2510 to the front of the rack. Locking the front panel is shown in the following figure.
Wiring Requirements
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or wiring your CN2510.
Wiring Caution!
Calculate the maximum possible current in each power wire and common wire. Observe all electrical codes
dictating the maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could overheat, causing serious damage to your
equipment.
Temperature Caution!
Be careful when handling CN2510. When plugged in, CN2510’s internal components generate heat, and
consequently the board may feel hot to the touch.