IMPORTANT - KEEP FOR FUTURE REFERENCE
DTCCGis8/05/08gen
Graco
®
model: SnugRide
®
- Double/triple carseat clip instructions
The stroller seat does not need to be removed to fit Carseat Clip.
Unfasten fasteners (x) either side
of right-hand seat and peel fabric
back, exposing right-hand side
tube and centre bar.
1
Recline right-hand seat slightly.
2
3
ALL MODELS
Loosen the strap beneath seat
at point
A
.
URBAN
These instructions are for the
Carseat Clip
that fits the SnugRide
®
infant
car seat made by Graco
®
only
. This
Carseat Clip
fits the following
model strollers:
DOUBLE U2204
WARNING
• Check you have the Graco
®
model: SnugRide
®
Car Seat for this Carseat Clip.
• Do not use this Carseat Clip until you have
read and understood the instructions!
• Incorrect use can mean serious injury or death
to an infant!
• Do not use this Carseat Clip on any other
stroller as it may be unsafe.
• Never leave your child unattended.
• Check that car seat and Carseat Clip are secure
and cannot move forward, back, sideways or
upwards.
• Make sure infant is harnessed into the
car seat using the car seat manufacturer’s
instructions.
• Do not leave baby in car seat (on or off stroller)
for long periods of time.
STAGE 1
Pull support wire out of
sunhood joint
A
while
pushing against stroller frame
with other hand
B.
NB: This
operation is child proof and
therefore requires a degree
of force.
Repeat step (1) on other
side.
Fold sunhood back to rest on
handlebar.
3
1. Temporarily Remove Sunhood
2
The sunhood wires need to be removed from sunhood joints to allow
Carseat Clip to be fitted. These wires are re-attached to stroller once
Carseat Clip has been fitted.
A
B
Sunhood Joint
URBAN
TRIPLE U3204
URBAN
DOUBLE T2204
TERRAIN
TRIPLE T3204
TERRAIN
1
STAGE 2
ALL MODELS
1. Partial Seat Unfastening
Note: The Carseat Clip fits to right hand seat only. Left and right are
determined from pusher position.
A
centre
bar
X
