Instructions for Ranch Series Auger Feeder Kit
Thank you for your purchase of a Moultrie Ranch Series Auger Feeder Kit. Please read this sheet before
operating the unit. If you should have any questions about this product or any other Moultrie product,
please contact us using the information on the back of this sheet. Allow us to better serve you by
activating your 1-year warranty online at
http://www.moultriefeeders.com/warranty
.
ASSEMBLE AUGER FEEDER KIT
A
Remove all hardware from packaging.
Bolt
M6 x 1 x 18
Qty. 7
Hex Nut
M6 x 1
Qty. 7
Flat Washer
M6
Qty. 8
From the inside of your feeder hopper, install (3) M6 bolts,
fitted with washers, through the mounting bolt holes on
the bottom.
Do not thread anything onto the bolts,
this will be the mounting hardware for the assembled
auger kit.
NOTE: Remove the rubber grommet in bottom of
hopper cone to avoid interfering with the grommet
on the Auger Kit.
On the right side of the auger kit, remove the access door by
unscrewing the (2) Phillips head screws.
The door will drop straight down after screw removal.
Mounting Hole
Bolt
Washer
Phillips
Screws
Access
Door
Remove the carabiner clip and rotate the main door downward to begin mounting the auger kit to your hopper.
Carabiner
Clip
Main
Door
With the main door open and the access door removed, lift the auger kit
up to the hopper, inserting the mounting hardware from STEP 2 through
the 3 mounting holes on top of the auger kit.
Be sure that the main door is oriented to be at the front of the feeder,
indicated by the stamping on the Hopper Cone.
View from inside hopper
Grommet
