Turn
Drum
upside down.
Drum
Bolts
Funnel
Short
Bolts
Place
Funnel
inside
Drum
with
small end of funnel facing down,
and attach with two
Short Bolts
using nuts and washers provided.
Place
Feeder
on
Drum
.
Attach
Feeder Legs
to Drum as
shown with
Long Bolts
using
nuts and washers provided.
Drum
Feeder Legs
Feeder
Feeder Leg Holes
Turn drum over, measure and mark the center of the bottom.
Center the template on the bottom of the drum and secure
with tape. Drill two 3/16" Funnel holes and three 5/16"
Feeder Leg holes.
Using a Hole Saw, drill a 2-1/4" hole in the center of the
bottom of your drum.
caution:
wear eye protection
Long
Bolts
THANK YOU
for your purchase of the Econo Plus Feeder Kit.
Please read this sheet before operating the unit. If you should have
any questions about this product or any other Moultrie product,
please contact us using the information below. To help us to better
serve you, please complete and mail the enclosed Warranty Card.
DRILLING YOUR DRUM/BARREL/BUCKET
MOUNTING THE FEEDER
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and the receiver
Econo Plus Feeder will mount to the bottom of any drum or bucke
t
Funnel Holes
Instructions for Econo Plus Feeder Kit
