Moultrie LX-30IR, User Manual, Page: 4 / 7

Capture Modes
Setting Camera ID
Press the (Select) button to select an
Identity for your camera. Choose between
nine (1 - 9) different numbers so the
locations can be marked every time the
camera is triggered. After the selections
have been made, press the (Select) button
and the LCD will display the time again. This
concludes the LCD readout display settings.
Setting Time Delay
To set the time delay, slide the (Delay) switch
to the desired time. There are 4 time delay
settings, 1 min, 5 mins, 10 mins and 30 mins.
Setting Image Quality
Slide the (Resolution) switch to the desired
setting. Choose one of 3 settings. High:
2560x1920 or Low: 640x480 for still images.
Choose (VID) for the video setting.
Sleep Mode
After all your settings have been made, slide the
(Mode) switch to (Auto) and close the cover.
Note: If there is no activity within 2 minutes,
the camera will enter sleep mode to conserve
battery life. The camera will then power up and
become active when motion is detected.
Photo Mode
To operate the camera in (Photo) mode, slide
the (Resolution) button to the (HI) or (LO) position.
Slide the (Mode) switch to (AUTO) position. The
LCD display will will count down for 10 seconds.
After the LCD goes off, the camera is ready for
capturing photo.
Video Mode
To operate the camera in (Video) mode, slide the
(Resolution) button to the (VID) position. Slide the
(Mode) switch to (AUTO) position. The LCD
display will count down for 10 seconds. After the
LCD goes off, the camera is ready for capturing
video. (10 second video clips at (30 FPS) frames
per second).
10
Use the steps below as a guide to quickly set up your camera so it will function
using the factory default settings.
STEP 1
Open camera cover. Install 4 C-Cell
Alkaline batteries. Make sure that
the polarities on the batteries match
the polarities indicated in the battery
chamber. Recommended for use:
Duracell ® or Energizer ® batteries.
STEP 2
Insert SD Memory Card until you hear
an audible click. Camera will not
operate without SD Card. Slide the
(Mode) Switch to Setup. Turn the
power ON. Press and hold (On/Off)
button until LCD activates. Set the
time and date with navigation
buttons, (Up/Down - Select/Enter).
STEP 3
Mount Camera in desired Location
using a mounting strap. Switch
camera to IR Aim.
Aim camera
using motion detection to
determine target area. Walk in
front of the camera at the desired
distance and the camera LED will
flash showing the covered area.
STEP 4
Set the (Delay) and (Resolution).
Slide the (Mode) switch to (Auto).
The camera will start count down.
Close cover and secure.
The
camera will operate using
(Default) settings. You may also
customize the settings if required.
Quick Start Guide
3