![background image](http://html1.mh-extra.com/html/moulinex/cookeo-touch-mini/cookeo-touch-mini_manual_1840122030.webp)
56
57
The cookeo touch mini pressure
fails to be built
and steam is not being
released properly:
•
The gasket seal is dirty or damaged.
Ensure that the gasket seal
is clean and in good condition.
•
The inner lid is missing or not tight
enough.
Ensure that the central nut
under the metal lid
is tight enough.
•
The locking rod is dirty
or the seal is missing.
Clean the locking rod
according to the instructions.
The locking rod
must be able to move up
and down properly.
Ensure that the seal
is correctly positioned
on the locking rod.
•
The decompression ball
is dirty or incorrectly positioned.
Ensure that the ball
is correctly positioned
and that the ball cover
is in the locked position.
Clean and dry the ball
and the support.
•
The edge of the bowl is damaged
or dirty.
Clean the bowl.
Ensure that the bowl
is in good condition.
•
If the locking rod is built upside down:
place the magnetic side of the
stem on the same side as the ball
The cookeo touch mini
does not decompress:
•
The ball coveris out of place:
Leave the cookeo touch mini
to cool down completely,
remove the metal lid,
and place the ball cover in the
correct position.
Water is leaking behind the
cookeo touch mini:
•
The collector is not in place or
is overflowing.
Ensure that the collector
is correctly positioned
behind the cookeo touch mini.
•
The bowl is too full.
Ensure that the contents do not
exceed the maximum volume.
•
If you are using certain ingredients
such as:
- cream,
- wine,
- or milk,
Respect the quantities shown
in the recipe.
These ingredients can cause
the cookeo touch mini to overflow.
The gasket seal should be
changed every three years
at an Approved Service Centre.