Uf251_01d_oi_e.doc / Aug-16
Page 10 / 25
4.
DIL Switch Settings
The DIL switch located on the top site of the unit provides
customer-specific settings of desired operation modes.
The switch settings below show normal operating mode with
current input and freely adjustable frequency range. No default
values will be loaded, the serial link is set to RS232 format and
to printer transmission mode.
ON
OFF
DIL-
switch
*)
Normal ( No Repeat)
Repeat
Printer Mode
PC Mode
Current input or Potentiometer
Voltage input
RS 232
RS 485
Normal conversion mode
Motorized Potentiometer operation
Unit loads default settings with every power up cycle
No loading of default settings upon power-up
100 kHz
10 kHz
1 kHz
Freely adjustable by register
1 2 3 4 5 6 7 8
*) It is a "
" to apply this setting when you like to use free scaling of the unit by PC
must
Changes of switch settings will become active only after the next power-up cycle!
