Rev. 12/2019
17
5.1
Unpacking
Unpack the SparkView high voltage indicator taking care not to damage it, and ensure that the
operating manual is always near to the device and is easily accessible. Check the contents for
completeness and verify that the equipment meets your application requirements.
Scope of supply
The scope of supply of the SparkView high voltage indicator consists of the following compo-
nents:
–
SparkView high voltage indicator
–
Mignon battery 1.5 V type AA (3x)
–
Operating manual
–
Transport case
Accessories:
–
SparkScan1 high voltage clamp including operating manual (optional)
–
BNC cable (optional)
5.2
Start-up
To put the SparkView high voltage indicator into operation, insert the batteries. Proceed as
follows:
1.
Loosen the battery compartment cover screws on the back of the SparkView with a screw-
driver and remove the battery compartment cover.
2.
Insert the three supplied AA batteries. Ensure that the polarity is correct.
3.
Put the battery compartment cover back on and secure it by tightening the battery compart-
ment cover screws with a screwdriver.
▸
The SparkView is ready for operation.
5 Operation
