Motortech EasyNOx, Operating Manual

Page: 92 / 142

8 General Operation
92 Rev. 06/2021
Access level Rights
Service – Operator rights
– Change settings of the following devices:
– NO
X
monitor
– I/O Communication Module
– Complete display configuration
– Activate devices
Master – Service rights
– Set system time and system date
– Enable/Disable access control
– Reset all PINs
– Firmware Update
Access to locked functions
If you would like to access a function with enabled access control, which ex-
ceeds your currently set rights, you will be prompted to enter the PIN for the
access level required.
8.5.1 Enabling/Disabling Access Control
Access control in as-delivered state
In as-delivered state, the access control is not enabled and all PINs are set
to

. After enabling the access control, assign an individual PIN for each
access level including Master (see Changing the PIN on page 95).
Enabling Access Control
Enable the access control for all access levels as follows:
1. Tap the Enable Control button.
▸ You are prompted to enter the PIN for the access level Master .