7 Wiring and Configuration
Rev. 06/2021
63
7.2.2
Grounding
The grounding cable (see position
in section
Components
X
sensor module must be connected to the earth of the system.
7.2.3
Wiring of Thermocouples
All cables must be fed through a cable gland at a suitable position of the CAN bus module. Use
suitable wire end ferrules for each wire that you place on a terminal.
Connect the first thermocouple to input 1. Optionally, connect the second thermocouple to input
2 (see section
Installation Locations of Thermocouples
on page 55). Depending on the layout,
connect the thermocouples as follows:
Layout
Input 1 (
T1
)
Input 2 (
T2
)
Before and after catalytic converter (
Before
& After Cat
)
Before catalytic
converter
After catalytic
converter
After catalytic converter (
One After Cat
)
After catalytic
converter
–
In two exhaust gas lines after catalytic
converter (
Two After Cat
)
First exhaust gas line:
after catalytic convert-
er
Second exhaust gas
line: after catalytic
converter
If you do not use input 2, bridge this input with a jumper between the ter and –. This
prevents the measuring circuit from being disturbed by interfering radiation.
Only use thermocouples with shielded leads. When connecting, make sure that the terminal
designation corresponds to the polarity of the thermocouples.
Connect the thermocouples as follows:
Connect the shields of the thermocouple leads with the cable glands. Do not lay the shields in-
side the CAN bus module.
Summary of Contents for EasyNOx
