Motortech EasyNOx, Operating Manual

Page: 48 / 142

48 Rev. 06/2021
6.1 Unpacking
Before unpacking, please observe the instructions in section Proper Transport on page 18.
To prevent condensation from forming in the sensing element of the supplied NO
X
sensor
P/N 56.03.003, you should avoid any temperature shocks when opening the packaging. Before
opening, allow the shipping unit to adjust to the mounting temperature, and after having
opened it, avoid temperature changes. The supplied NO
X
sensor must not be taken out of its
packaging in polluted air and under bad weather conditions (e.g. oil, water, snow, dust, sand,
smoke).
Unpack the components of the EasyNO
ₓ
system without damaging them and ensure that the
operating manual is always within reach of the device and easily accessible. Do not remove the
protective cap from the sensing element until you are instructed to do so within this operating
manual (see section
Mounting the Sensing Element of NO
ₓ
Sensor P/N 56.03.003 on page 50).
Check the contents for completeness and verify that the equipment meets your application re-
quirements.
Scope of Supply
The scope of supply of the EasyNO
ₓ
includes:
– EasyNO
ₓ
incl. housing and inserted SDHC card 16 GB
– Sealing plugs for EasyNO
ₓ
housing (4x)
– Sealing insert for cable gland M25 on EasyNO
ₓ
housing, 3x
⌀
7 mm (2x)
– Sealing insert pin for sealing insert opening
⌀
7mm (6x)
– Up to two CAN bus/NO
X
sensor modules pre-mounted on a mounting plate, each including
– Sealing insert pin for cable gland M16,
⌀
9 mm
– Sealing insert pin for cable gland M12,
⌀
7 mm (2x)
– Welding boss for NO
X
sensor
– Locking screw for welding boss
– Operating manual
– EXTENDED package: up to two I/O communication modules
Optional accessories:
– CAN bus hybrid cable for connecting the CAN bus modules to the EasyNO
ₓ
and to the power
supply
– Sheath thermocouples with suitable compression fitting
– Manifold pressure sensor
6 Installation Instruction