Motorola TK30, User Manual

Page: 11 / 37

10 install the harness
6 Slide mounting bracket onto arm.
7 Attach mounting base to flat spot location on your
vehicle.
8 Attach one side of mounting tape (supplied) to back of
mounting bracket.
9 Verify cable is fitted into a groove on the back of the
UIM. The cable must be contained in the slot to
provide a flat surface for mounting.
10 Remove other side of mounting tape on bracket, and
press the UIM firmly into place.
11 Connect cable connector P (shown on page 7) to the
junction box connector B (shown on page 4).
install the microphone
Caution: The location of the microphone must not
interfere with the vehicle's air bag deployment. Also, the
microphone cable should not pass in front of or interfere
with the deployment of any vehicle airbags. In particular,
side airbags located with the windshield pillar or door jamb.
1 Mount the microphone in a suitable location using
either the screw, velcro, or clip (supplied).
• The preferred spot to mount the microphone is on
the overhead console/dome light assembly near
the front center of the vehicle, away from the
window, pointed toward the driver's mouth.
• Locate the microphone no more than 16 inches (40
cm) from the driver.
• Do not allow anything (such as a rear-view mirror or
sun visor) to block the path between the
microphone and the driver.
• Mount the microphone firmly so that vibrations do
not affect audio quality.