34
Changing a Talkgroup during/on receiving a call
You can select a group folder without an interruption on
receiving and during a call.
Selecting a group on receiving a call
If you select a group and a non-Emergency call is incoming,
MTM800 display remains unchanged while you hear the call.
During the selection you cannot see calling party information.
Selecting a group during a call
If you start selecting a group during a call,
Group In Use
or
Emgcy In Use
display disappears.
Selecting a Range
To select a range:
1.
In Group Mode, press
Optns,
followed by
Range.
2.
Use the navigation key to scroll through the ranges.
3.
Press
Ok
to select the range (or press and hold
PTT
to start
the call in the new range).
Activating/Deactivating Scanning
See “Setting Talkgroup Scanning” on page 93.
When an Emergency Call is received, then selecting is aborted,
the MTM800 switches to the group mode and Emgcy In Use
display appears.
The Service provider can configure range scrolling to:
• Stay in range — when the range end is reached during
talkgroup scrolling, further scrolling restarts the range
talkgroup list.
• Scroll to next range — when the range end is reached during
talkgroup scrolling, further scrolling switches to the talkgroup
list in the next range.
6815321H01_KOR.book Page 34 Thursday, November 13, 2008 8:06 AM
