EWB100 Usage and Deployment Guide
Rev 1.13
Page 31
The default is 0xe0 (ie. All rates about 24 mbits are not requested during
association.
It should be noted that the EWB100 can use any rate supported by the AP. This
command simply limits what rates the AP can use to send to the EWB100
device.
5.2.23 Cradle low power mode
If sitting in the cradle, the device will scan for new APs less often when in the
cradle than when not in the cradle. This will reduce power consumption in
situations where the cradle is located in an area of poor RF coverage. The
default is disabled. The function is controlled by the following configuration bit in
the “misc new3” command
:
The bit value is 0x0001.
The default value is disabled.
5.2.24 Fixes for roaming problems
A new option has been added to fix some roaming problems that could cause
long periods of “no association” when the device receives a deauth packet. Since
these changes are in code that has not changed in a long time, they are disabled
by default. They may be enabled by the command:
set misc new x
where x is the bit map value 0x800.
The unit must be reset after changing this parameter for it to take effect.
Summary of Contents for TEAM Badge (EWB100)
